cold conveyor belt vulcanizing patch

1 belt damaged parts will fit with the angle grinder for grinding tungsten steel grinding disc.
2 According to the size of damaged parts conveyor select the appropriate semi-vulcanized layer conveyor belt repair sheet or patch strip (strip or patch repair a damaged piece at least large parts of 15 ~ 20mm) Yin U.S. special recommended to use a semi-vulcanized layer repair section , Wheel Loader, without a layer of semi-cured adhesive surface of the material proposed to conduct in-depth polished.
3. The Asphalt Mixing Plant repair of damaged parts and semi-vulcanized rubber belt surface for brushing, dry for a while, and then the second time brushing (dry set to sticky until normal circumstances usually within five minutes) .
4 would be posted on the conveyor belt repair section straightened polished surface with a rubber hammer or compactor wheel to beat compacted out of the air.
Tips: If the ambient temperature is too low or a hot air gun is recommended tungsten heating 0.5-1 hours, allowing an appropriate extension of time if the heating time, will help increase the strength of the adhesive surface.